Generally, the screen printing plate made by an Open Type Rotary Screen Printer must be dried with a hair dryer and placed in the sun for a few hours.
Before using the silk screen, first check whether the patterns and fonts in the silk screen are clear. If there are some small spots around the pattern, it can be filled with patch glue;
During the commissioning process, the screen printing plate should be kept parallel to the product bearing frame as much as possible, and the scraper blade should be slightly stressed to ensure that the screen printing plate will not be easily broken;
In general, the effect of scrubbing the silk screen with 719 thinner is better in production, but do not scrub the silk screen with alcohol, because there is a certain amount of moisture in the alcohol, and contact with the silk screen will play a certain unfavorable situation (such as the patch board falling off, Some smaller fonts are easy to fall off);
A good silk screen can be used several times normally. If the output is low during production, the silk screen should be removed and cleaned as soon as possible. At the same time, during the cleaning, do not use a knife, you can use some harder paper;
After the Hot Air Stenter is cleaned, make sure that the patterns and fonts in the silk screen are clear, then blow it dry with a blower, and put it on the designated position.